1. Inside & outside Traction Tech 3.0
Traction Tech 3.0 features three bumps per edge (front binding, board center, back binding). The middle bump is slightly bigger than the outside bumps for better grip.
Inner edge Traction Tech
Inner edge Traction Tech improves splitboard edge grip on ascent. Three sidecut bumps on each side of your binding keep your locked in on icy skin tracks no matter which way you are traversing.
2. Progressive sidecut
At the far ends of the sidecut, the radius is incrementally increased as the edge reaches the contact point. Gradually increasing the sidecut radius towards the contact point delivers smoother turn initiation and exit as the edge tracks in and out of the snow with a less abrupt transition.
3. Quick Tension Tail Clip
Built-in climbing skin tension system using pre-cut notch that eliminates the need for a traditional skin tail clip.
4. Boltless Bridge
The Boltless Bridge eliminates split clip attachment hardware from the base of the board by re-profiling the wood core at the clips. The wood core under the clips is thicker, providing better torsional stiffness and a more powerful connection at the split clips.
Twin flex pattern
Balanced flex pattern with equal stiffness and torsional response in the nose and tail.
How a board glides in powder, crust, corn or any snow more than an inch deep, is dictated by it’s front contact point and just past it. Next time you are in soft snow watch how much snow comes over the corner of the nose near the contact point. The billowing snow coming out from behind the tip means you are plowing through it which is obviously slowing you down. By adding a blunt nose you get the float benefits of a much longer nose without the ‘snow plow’ rounded tip and it’s extra swing weight. – Jeremy Jones
A unique rocker/camber flex pattern defined by evenly balanced tip and tail rocker and camber between the bindings. Camrock improves freestyle finesse by keeping your tips playful while maintaining the power and pop of camber underfoot.
3D Contour Base 2.0
Moderate 3D-base contours featuring an even balance of 4mm spoon bevel in the nose and 4mm spoon bevel in the tail. Spoon bevel starts at the rocker point.